Loading cover... Drag cover to reposition

Earl Miller

Last seen online, 7 hours ago
  • Dean Woodyatt (On one of the FB groups) posted a pretty straightforward method for leveling your D9. "I had trouble getting stuff to stick.....1 - CLEAN the bed, with cleaning stuff (isopropyl alchol works apparently, i've used baby wet wiptes) 2 - LEVEL the Z axis.....3 - LEVEL the bed manually - go to LEVELLING in software , get it so Z is hovering and correct, just gripping paper......then TURN OFF printer, manually move close to each corner and use the paper gripping method by adjusting the screws so that the paper just grips in each corner..........THEN turn on printer, and LEVEL the printer............after that, my stuff sticks fairly well, but not on some parts of the bed0"
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
"It's a collaborative effort and vision of Wanhao's Gary Chen, myself, and a growing list of enthusiastic people who want to further the enjoyment and viability in business, education, and other areas of interest with 3D printing by offering useful resources and support to achieve this goal."          ~Earl Miller

Copyright © 2017-2018 Earl Miller, Wanhao and Wanhao University. All Rights Reserved. No part of this site may be reproduced without express consent by the owners for their respective content. Wanhao University is a creative IP (intellectual property) soley owned by Earl Miller.